|
Post by rudy9443 on Aug 7, 2007 9:28:01 GMT -5
I was wondering if it would be possible to set where a menu opens up to? I know the angle settings are going to be implemented in stage 5 but is it possible to move the actual menu "anchors"? This would be great so that I can finally put my less used menus towards the side of the sphere near the side of my screen and have them pop up above the sphere(mainly for my "warcraft menu" buttons and profession buttons as in my terribly drawn example
|
|
|
Post by Haggo on Aug 7, 2007 13:35:56 GMT -5
Something similar has been suggested in this thread, at reply #6. At least that is what I meant. That is something I can look into as well.
|
|
|
Post by Moongaze on Aug 7, 2007 14:59:11 GMT -5
I was basically going to add an "x offset" and "y offset" for the button menu opening. Basically, you would set the angle of the menu and then define the x and y offset where the anchor will be located. If you were to use the bottom button of the sphere (at the 6 'o clock position) as an example and set the menu angle to 90 (straight up) ... it would open right over the sphere as well. However, setting the y offset to -100 would open the menu above the sphere, and it would still being going straight up. These offsets will be relative to the menu button it is based on, so if you move the sphere or undock the menu button and move it, the menus will move with it. This will be pretty flexable for where it will be located. I might also just add a small "anchor" section to the submenu buttons so you can just drag it. It would be easier that way. I will have the number input way as well, for those who want to fine-tune the positioning. Hope that answers your questions / suggestion
|
|
|
Post by rudy9443 on Aug 8, 2007 8:48:45 GMT -5
Sounds good to me Thanks for the quick response! Im already loving this addon and the additional changes proposed for this mod completely blow me away, great job moon!
|
|